Block jointing mortar
Hassle free, fast and durable block fixing solutions !
Why to use block jointing adhesive instead of mortar?
Traditional mortar made up of cement, sand and water has much higher strength and low flexibility. Hence, when AAC blocks expand at higher temperatures, traditional mortar, due to it's stiffness will not allow the blocks to expand. This will generate high internal stresses in blocks and will develop cracks. These cracks may further result to weakening of plaster, dampness in wall and other health hazards. Hence, self curing block jointing adhesive containing cement, fine sand, polymers and water must be used to joint AAC blocks. Highly flexible adhesive will ensure that enough room is provided to blocks for thermal expansion.
Saint Gobain Weber Blokfix
40kg pack
Weber blokfix is a self curing mortar used for fixing masonry units like blocks. It is made from cement, sand, polymers that ensures better bonding strength between the blocks.
Key features :
Ready to mix & easy to use
Self curing
Good coverage
High bond strength
No shrinkage & leakage
Single component
About
Clean the surface to remove loose particles.
Prewet the blocks
Mix 2.5 part powder to 1 part water to make a stiff, workable paste. Always add powder to water.
Rest the mix for 2-3 mins to get mature.
Do not add extra water to extend pot life.
Apply the mix using trowel.
Features
For 4mm bed thickness
Plastering can be done after 7 days
Self curing
Suitable for undulating surfaces
Brochure
Redwop Blokfix
40 kg pack
Redwop Blockfix is a high strength adhesive for quick and firm laying of AAC blocks and other masonry units with thin joints. Made of cement, graded sand and blended with polymers, it provides high strength and water retention properties
Key features :
Ready to mix & easy to use
Self curing
Good coverage
High bond strength
No shrinkage & leakage
Single component
About
The bonding surface should be cleaned.
Add powder to 25-28% water and mix thoroughly.
Leave the mix to slake for 5-10 min and re-mix before use.
Apply a uniform layer of 3-4mm on the clean surface and lay the blocks.
Embed each block by properly wiggling and gently pressing with the handle of a trowel.
After placing the first unit, apply the mixture of same thickness on both sides ensuring it is level.
Features
Self curing.
Premixed and ready to use.
High bonding strength & coverage.